Wenzhou Prance Hydraulic Equipment Co., Ltd.
A hydraulic motor crossover relief valve connects one motor work port to the other when differential pressure exceeds its setting. It can limit shock during reversal or deceleration, but it does not automatically provide controlled overrunn
Hydraulic motor efficiency calculation separates volumetric efficiency, mechanical efficiency, and overall efficiency. Volumetric efficiency compares actual speed with the speed predicted from inlet flow and displacement; mechanical efficie
Hydraulic pump destroke testing checks whether a variable-displacement pump reduces output when its control condition is reached. The test must observe pressure, flow, case drain, temperature, command state, and circuit demand together; pre
The load sensing vs pressure compensated pump choice changes how a variable pump decides its displacement. A pressure-compensated pump responds to outlet pressure alone, while a load-sensing control compares pump pressure with a remote load
Hydraulic pump pressure pulsation is the repeating pressure variation created as pumping chambers connect to the outlet and the circuit responds. Its amplitude depends on pump geometry, operating point, trapped-volume timing, fluid compress
Hydraulic pump torque calculation converts displacement and pressure into the shaft torque a prime mover must supply. The theoretical relationship is torque = pressure × displacement ÷ 2π; practical sizing must then account for mechanical e
The proportional valve vs servo valve decision is a system-level choice. Both meter hydraulic flow in response to an electrical command, but servo valves usually target higher dynamic response and tighter control with stricter fluid-cleanliness and c
A load sensing hydraulic valve sends a signal representing the highest active load back to a compatible variable pump. The pump then supplies enough pressure to overcome that load plus a control margin. When properly sized and compensated, this arran
A hydraulic valve power-beyond port carries pressurized carryover flow to a downstream valve, while the tank port returns exhaust and leakage flow at low pressure. They are not interchangeable. A power-beyond sleeve separates the high-pressure carryo
A hydraulic motor braking circuit controls a load that can drive the motor faster than pump flow would command. A correctly applied brake or counterbalance valve maintains controlled outlet resistance, admits pilot pressure for motion and works with
Hydraulic motor back pressure is the pressure at the motor outlet that opposes return flow. Some back pressure is normal in closed circuits, braking arrangements and long return lines, but it reduces the pressure difference available to make torque.
Hydraulic motors in series share the same flow path, while motors in parallel receive flow through separate branches. Series plumbing can synchronize displacement volumes under similar loads but adds pressure demands and exposes the downstream motor